You may have to drill holes through studs or through the top plate of walls to reroute wires. If so, be sure to center the holes on the stud. If the plastic-sheathed cables are too short to reach the next box when you reroute them, you can add a junction box and splice on a length of cable. The new box must be accessible either in the attic space or through a blank cover on the wall or ceiling.
I just finished "re-modeling" my garage...before I touched it it had just taped drywall and concrete block walls, unfinished cement floor, wires for the garage door openers hanging all over the place, holes in all the walls/ceiling. It was a typical, dirty, dark garage.I painted the concrete walls with Behr waterproof masonry paint and the rest of the walls and ceiling with the same color behr paint (twilight gray-to lighten it up).I did the floor with Behr 1 Part Epoxy, which, takes forever to prep for, but the result is worth it. You first need to sweep very good, then clean/de-grease and etch the concrete using a floor cleaner rented from HD...then let it dry. I let it dry for about 2 weeks. Once I was sure the concrete was dry, I applied 2 coats of concrete bonding primer. I let that dry for about 24 hours, and I was finally ready for the paint. The paint goes on easy, one coat was plenty. I sprinlled in some color flakes and let it dry 24hrs. I then began my first of three coates of low gloss sealer. The finished result was very pleasing...I then re-installed my Gladiator Garage Works 8 foot work bench, wall cabinet and tool chest as well as a second wall cabinet and large gearbox that I purchased for my new garage... I also built a wooden cabinet around the circuit breakers and painted it gray along with the framing for the garage doors, a beam in the middle and the door into the house. I finished with gray vinyl trim molding around the walls.I also mounted the bikes, a shop Vac and misc. brooms, saw horse, etc... on the wall(s). All of the wires from the garage door openers were hanging down and sloppy (prev. owner) so I disconected everything and ran it through PVC for a cleaner look. I then added a few finishing touches, Bud Light neon clock, pictures (NE Patriots Cheerleaders), and mounted my novelty license plate collection as well as a few other items...Moving all of my furniture/tools out of the garage was a big project in itself, and I lost my basement(i.e. Gym) for about a month and a half, but the end result is a very clean, organized garage that is "my" place...
For a garage-to-utility-room conversion, budget at least $6,000 for appliances, a utility sink, and space for sorting, folding and hanging laundry. A new utility room in place of an old garage brings convenience into your life, especially if you've spent years dragging loads of laundry up and down the stairs. This conversion will cost a bit more due to the addition of plumbing, but it'll be worth it.
The extras on a garage often get short attention, but those little details can make a big impact. Take lighting and house numbers: Choices more in step with your garage's style can tie together paint, materials, and more. Use proportion as your guide when selecting fixtures: Low-slung styles such as this garage work better with small to medium fixtures.
The overhead garage door can be a big source of drafts and heat loss. Recently installed doors usually include a weather-stripped stop around the perimeter. But older doors may be lacking a weather strip. Luckily, it’s an easy fix. Garage door weather stripping is available at home centers and hardware stores, and installation is straightforward. If your overhead door is uninsulated, search online for “garage door insulating kits.”

You may have to drill holes through studs or through the top plate of walls to reroute wires. If so, be sure to center the holes on the stud. If the plastic-sheathed cables are too short to reach the next box when you reroute them, you can add a junction box and splice on a length of cable. The new box must be accessible either in the attic space or through a blank cover on the wall or ceiling.
The truth abut garage remodel ideas that increase home value is that there are many to choose from. There are some ideas that increase home value, as well as overall home remodeling ideas that do the same. The trick is finding the ones that will work for your home. Not every idea will work for every home. Always take into account how everything in your home fits together, and use the ideas that work best for your specific situation.

With its 3D Warehouse and simple user interface, you can certainly be on your way to designing a SketchUp project within minutes. However, If you’re a newbie or have a more complex vision, SketchUp’s own learning center is a great place to start, with several handy video tutorials. There are also lots of user-created SketchUp tutorial videos on YouTube. And if you’re really serious, there are third-party SketchUp training programs available, too.
I just finished "re-modeling" my garage...before I touched it it had just taped drywall and concrete block walls, unfinished cement floor, wires for the garage door openers hanging all over the place, holes in all the walls/ceiling. It was a typical, dirty, dark garage.I painted the concrete walls with Behr waterproof masonry paint and the rest of the walls and ceiling with the same color behr paint (twilight gray-to lighten it up).I did the floor with Behr 1 Part Epoxy, which, takes forever to prep for, but the result is worth it. You first need to sweep very good, then clean/de-grease and etch the concrete using a floor cleaner rented from HD...then let it dry. I let it dry for about 2 weeks. Once I was sure the concrete was dry, I applied 2 coats of concrete bonding primer. I let that dry for about 24 hours, and I was finally ready for the paint. The paint goes on easy, one coat was plenty. I sprinlled in some color flakes and let it dry 24hrs. I then began my first of three coates of low gloss sealer. The finished result was very pleasing...I then re-installed my Gladiator Garage Works 8 foot work bench, wall cabinet and tool chest as well as a second wall cabinet and large gearbox that I purchased for my new garage... I also built a wooden cabinet around the circuit breakers and painted it gray along with the framing for the garage doors, a beam in the middle and the door into the house. I finished with gray vinyl trim molding around the walls.I also mounted the bikes, a shop Vac and misc. brooms, saw horse, etc... on the wall(s). All of the wires from the garage door openers were hanging down and sloppy (prev. owner) so I disconected everything and ran it through PVC for a cleaner look. I then added a few finishing touches, Bud Light neon clock, pictures (NE Patriots Cheerleaders), and mounted my novelty license plate collection as well as a few other items...Moving all of my furniture/tools out of the garage was a big project in itself, and I lost my basement(i.e. Gym) for about a month and a half, but the end result is a very clean, organized garage that is "my" place...
The overhead garage door can be a big source of drafts and heat loss. Recently installed doors usually include a weather-stripped stop around the perimeter. But older doors may be lacking a weather strip. Luckily, it’s an easy fix. Garage door weather stripping is available at home centers and hardware stores, and installation is straightforward. If your overhead door is uninsulated, search online for “garage door insulating kits.”
I stink at drawing. So pencil and paper isn’t an option for me when working to design my perfect garage (which I’ll unveil at some point in the future). Instead, I’ve been using SketchUp Make —a free 3D modeling software program, once owned by Google, that’s been around for almost 20 years now. And while CAD-style programs can be quite intimidating, SketchUp is super-easy to use and has a huge active community made up of all kinds of people—from architects and interior designers to woodworkers and other creators.
Heating & AC ($1000-$5000): Adding central heat and air into your garage can either be simple or difficult. If you have a robust heating and air conditioning system in place it is as simple as expanding your existing ducting. If the additional square footage is more than your system can handle you will need to add in a new unit. Luckily, a small garage usually is able to be fit into your existing system.

We had an excellent experience with Renown. Fast responses, excellent service, and they fought with our insurance company for what was truly needed. My only regret was not letting them handle the insurance company conversations from the beginning, rather than dealing with trying to coordinate myself. Once they took over direct communication everything went very smoothly. I would highly recommend Renown Roofing and Construction.
Note: Here’s how we can help: 24hplans has team of highly-trained, professional architects and drafters who can prepare any kind of site plan in the shortest amount of time possible, so that you can easily obtain that building permit and get on with your project. Use the promotion code: 24hplans-20off to get a 20% discount off any package. — Please note this is a limited time offer, exclusive to the readers of our blog. This offer is not being advertised anywhere else.
Before launching a project, the homeowner should draw up a plan that takes into account the various ways the garage could ideally be used. GarageAbility, for instance, will divide a garage into zones for storing garden equipment, sporting goods and tools as well as space for working on hobbies, then help the homeowner determine the storage systems that will work best for their belongings.
Your garage is an often untouched part of your home. The uncomfortable truth is that far too often it is not used for our vehicles. A study put the percentage of homes that actually use their garages for parking at an astonishing 15%. This means the overwhelming number of garages are merely storage rooms.  This is especially true when you have a smaller one. The costs involved in remodeling your garage can seem overwhelming. Our guide makes it easier to wrap your head around.
Paint manufacturers have recognized these problems and have come to the rescue with new solutions. But a word of advice: If your garage floor sees heavy water leakage, if it's badly cracked or if it's damp and slimy all summer, don't apply any coating. In those cases, you're better off simply keeping it as clean as you can and then calling it quits.
×