Paint manufacturers have recognized these problems and have come to the rescue with new solutions. But a word of advice: If your garage floor sees heavy water leakage, if it's badly cracked or if it's damp and slimy all summer, don't apply any coating. In those cases, you're better off simply keeping it as clean as you can and then calling it quits.
The first step is often fixing a cracked floor or leveling it, and sometimes even staining it to make it look more attractive; the repairs cost $500-$12,500, and stains range from $2 to $10 per square foot. Drywall is typically put up, which costs from $1 to $2 per square foot. Adding boards for a storage space above the garage typically costs about $2 per square foot.
For a garage-to-utility-room conversion, budget at least $6,000 for appliances, a utility sink, and space for sorting, folding and hanging laundry. A new utility room in place of an old garage brings convenience into your life, especially if you've spent years dragging loads of laundry up and down the stairs. This conversion will cost a bit more due to the addition of plumbing, but it'll be worth it.
If you decide to expand your garage to make more room for tools or storage, this is considered adding on to your home, and costs will typically go up. Home addition costs fall between $20,000 and $70,000 for most homeowners, depending on the size and type of space built. Your contractor will frame out new walls and expand the room's foundation. If you intend to keep the space the same only reorganizing it, you may have only the costs associated with purchasing and installing shelving and cabinetry.
One of the best ways to have a garage space that increases your home value is to make sure it is in good repair. When a potential buyer does their very first walk through your garage can help make or break the sale. If it hasn’t been touched in 20 years the time to spruce it up is before the first buyer comes to look. When thinking about a garage that is in good repair think about things such as;
Wall Units: If you have a big enough garage, wall units for storage can make your garage a great selling point. This can be a project you do yourself for a few hundred dollars. If you are not a do-it-yourself sort of person look for options that don’t have the look of interior cabinetry. Select cabinets that look like they belong there.  The cost for garage cabinets ranges from a few hundred to a few thousand dollars.
And you really need your investments protected, but you just don’t have the funds to build some of these other options. Well, don’t give up hope. This video shows you how to build a pretty decent structure that will do what you need it to do for basically no money. And honestly, if you have the materials on hand it could actually be built for free.
As you plan, the following tips can be indispensable. Don’t start without giving this list a look. Our list can save money, time, and money, and hassle. Go over these tips and apply all the ones you can to your own project. Remember that this is a starting point and that you should try to use these to help your own brainstorming for more ideas specific to your own situation.

Like wood stains, masonry stains are less viscous than paints. They soak into the masonry and don't form a film the way paint does. Unlike film-forming coatings, stains won't make your garage floor feel like the deck of an aircraft carrier. Because of this, stains are somewhat more forgiving and easier to apply and reapply as they wear off and become dirty. One of the oldest (perhaps the oldest) masonry stains available is H&C, now owned by Sherwin-Williams and sold at local paint stores. This venerable brand has been used in the Southern U.S. for many years. It's available in a wide range of colors and it can be tinted to any color you prefer. It's available in two formulations: a solvent-base (that is unavailable in California) and a waterborne acrylic available nationwide. The solvent-based formulation is the tougher one, so if you have both available, choose the stronger route unless you're very sensitive to solvent fumes.

I just finished "re-modeling" my garage...before I touched it it had just taped drywall and concrete block walls, unfinished cement floor, wires for the garage door openers hanging all over the place, holes in all the walls/ceiling. It was a typical, dirty, dark garage.I painted the concrete walls with Behr waterproof masonry paint and the rest of the walls and ceiling with the same color behr paint (twilight gray-to lighten it up).I did the floor with Behr 1 Part Epoxy, which, takes forever to prep for, but the result is worth it. You first need to sweep very good, then clean/de-grease and etch the concrete using a floor cleaner rented from HD...then let it dry. I let it dry for about 2 weeks. Once I was sure the concrete was dry, I applied 2 coats of concrete bonding primer. I let that dry for about 24 hours, and I was finally ready for the paint. The paint goes on easy, one coat was plenty. I sprinlled in some color flakes and let it dry 24hrs. I then began my first of three coates of low gloss sealer. The finished result was very pleasing...I then re-installed my Gladiator Garage Works 8 foot work bench, wall cabinet and tool chest as well as a second wall cabinet and large gearbox that I purchased for my new garage... I also built a wooden cabinet around the circuit breakers and painted it gray along with the framing for the garage doors, a beam in the middle and the door into the house. I finished with gray vinyl trim molding around the walls.I also mounted the bikes, a shop Vac and misc. brooms, saw horse, etc... on the wall(s). All of the wires from the garage door openers were hanging down and sloppy (prev. owner) so I disconected everything and ran it through PVC for a cleaner look. I then added a few finishing touches, Bud Light neon clock, pictures (NE Patriots Cheerleaders), and mounted my novelty license plate collection as well as a few other items...Moving all of my furniture/tools out of the garage was a big project in itself, and I lost my basement(i.e. Gym) for about a month and a half, but the end result is a very clean, organized garage that is "my" place...


The truth abut garage remodel ideas that increase home value is that there are many to choose from. There are some ideas that increase home value, as well as overall home remodeling ideas that do the same. The trick is finding the ones that will work for your home. Not every idea will work for every home. Always take into account how everything in your home fits together, and use the ideas that work best for your specific situation.
Start by insulating the walls. Buy unfaced R-13 batts for 2×4 walls and unfaced R-19 batts for 2×6 walls. Match the width of the batt (15-1/4 in. or 23-1/4 in.) to the stud space. Cut batts carefully for a tight fit. Next, staple 4-mil poly to the walls and ceiling. Embed the poly sheeting in caulk around the perimeter of each piece to create an airtight seal. Seal the seams between sheets and seal the poly to electrical boxes with caulk or special sheathing tape (it’s typically red and looks like packing tape).

Every project comes down to cost, so it only makes sense to start there. According to our garage remodeling cost estimator, the average garage remodel runs $8,582. Keep in mind, this takes the full garage into consideration. That includes the garage door, flooring, windows and plenty of other renovations. For those remodeling one aspect of their garage, of course, expect the final price to be much less. In fact, we have even seen garage remodels cost as low as $900.
×